I found your products after searching the web on how to use OEM key to remote start a car. So I decided to install one on 2010 mazda3 (non push button start).
I bought the FLASH-LINK and EVO-ALL by mistake instead of EVO-ONE, and when I realized it requires another remote start module, I called your support and was advised to buy EVO-ONE. I asked if I can use my OEM remote to start the car with it and was told yes. So I returned EVO-ALL and bought EVO-ONE. And now in the middle of installation (after 4 hours), and I can not get the module to recognize my OEM fob.
SO I searched all over the web and your Q&A trying to figure out why the blue LED is not flashing when I press buttons on the fob.
NOW after spending a few hours on this issue, I came to the conclusion that this module does NOT work with the OEM key fob!
Why doesn't your web site make this clear?! Here: http://fortin.ca/en/vehicles/mazda/3/2010/ it should state that the OEM fob is not supported for this vehicle. WHY DOES IT NOT SAY THAT?
After some time searching, I tried selecting another car that I knew supported 3x to start (2014 Tundra) and looked at the page for it: http://fortin.ca/en/vehicles/toyota/tundra/2014/ And what do you know! Turns out there is a new feature listed there for 3x to start. Wish I knew earlier that this feature was not supported for my car.
Now I can't return the EVO-ONE that I have because it has the automatic transmission loop cut now, and a few wires trimmed. :(
Is there any chance a firmware upgrade is coming up which will let me use the OEM fob?
Thank you